| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Seat | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM00000333D004X |
| Title: SEAT: REAR NO. 1 SEAT ASSEMBLY: REMOVAL (2008 Sequoia) | ||
REMOVAL
HINT:
- Use the same procedure for the LH side and RH side.
- The procedure listed below is for the RH side.
1. REMOVE REAR SEAT CUSHION HINGE COVER LOWER RH
2. REMOVE REAR FLOOR STEP NO. 1 COVER
3. REMOVE REAR FLOOR STEP NO. 2 COVER
4. REMOVE REAR DOOR SCUFF PLATE RH
5. REMOVE REAR SEAT TRACK BRACKET COVER OUTER
(a) Operate the seat track adjusting handle to move the seat to the rearmost position.
|
(b) Disengage the 2 claws and remove the seat track bracket cover. |
6. REMOVE REAR SEAT TRACK BRACKET COVER INNER
|
(a) Disengage the 2 claws and remove the seat track bracket cover. |
7. REMOVE SEAT TRACK BRACKET COVER INNER
(a) Operate the seat track adjusting handle to move the seat to the foremost position.
(b) Disengage the 6 clips and remove the seat track bracket cover.
8. REMOVE SEAT TRACK BRACKET COVER INNER (w/ Center Seat)
(a) Operate the seat track adjusting handle to move the seat to the foremost position.
(b) Disengage the 9 clips and remove the seat track bracket cover.
9. REMOVE REAR NO. 1 SEAT ASSEMBLY RH
|
(a) Remove the 2 bolts. |
(b) Operate the seat track adjusting handle to move the seat to the rearmost position.
|
(c) Remove the 2 bolts. |
(d) Operate the seat track adjusting handle to move the seat to the center position.
(e) Remove the rear No. 1 seat.
NOTICE:
Do not damage the vehicle body.
10. REMOVE REAR NO. 1 SEAT ASSEMBLY RH (w/ Seat Heater System)
|
(a) Disconnect the seat heater connector and disengage the wire harness clamp. |
|
|
(b) Remove the 2 bolts. |
(c) Operate the seat track adjusting handle to move the seat to the rearmost position.
|
|
(d) Remove the 2 bolts. |
(e) Operate the seat track adjusting handle to move the seat to the center position.
(f) Remove the rear No. 1 seat.
NOTICE:
Do not damage the vehicle body.
|
|